nettechonline

Tech Supp - The Final Frontier!

  • Increase font size
  • Default font size
  • Decrease font size
Home Cisco Cisco Switch Cisco Switch Stack - Default Setup

Cisco Switch Stack - Default Setup

E-mail Print PDF

How to default a once stacked Cisco 3750 to a single switch

 

You need to provision it as an stand alone switch:

use this command:

 

Switch-B(config)#switch 1 provision <switch type)

 

If the switch was number 2 in the stack this command will make it one.

 

There is more to this story...

In order to get a switch back to position 1 you have to complete this in a few steps.

Otherwise you will still see the newly appointed switch 1 and the old position with all ports showing...

                     switch [current stack number] renumber 1

Then once you have the switch renumbered do a sh ip int brief    <3750(config)#show ip interface brief>

You will see 24 or 48 ports in both positions. In my case I had a switch 3 and moved to 1 and completing the sh ip int brief will show both positions.

Now you can removed the orphan position, in my case I needed to remove position 3 on a 48 port 3750.

<3750(config)# no switch 3 provision ws-c3750-48p>
<3750(config)# exit>
<3750# write memory >

This works.... I originally used the first method however if you try this you will see what I mean about keeping the original switch position.

It will still show ports on the old number and new....

H.


 

Last Updated on Wednesday, 20 July 2011 06:34